Swift L4-1298cc 1.3L SOHC MFI (1997)
Case: Service and Repair
Right Case
1. If reverse gear shift lever has been removed, fasten it with two bolts after applying thread lock cement.
Tightening Torque
(a): 18 - 28 Nm (13.5 - 20.0 ft. lbs.).
NOTE:
^
When installing reverse gear shift lever, set distance "a" between lever end and shaft bore to be 5 mm (0.2 inch).
Distance "a": 5 mm (0.2 inch).
^
Distance "a" can be measured by installing reverse gear shaft provisionally.
^
When "a" is 5 mm (0.2 inch), clearance between reverse idler gear groove and shift lever end will be 1 mm (0.04 inch).
2. Install input shaft oil seal facing its spring side upward. Use special tool and hammer for installation and apply grease to oil seal lip.
"B": SUZUKI SUPER GREASE A, or equivalent.
Special Tool(A): 09951-76010 or equivalent.
3. Install countershaft R bearing cup by using special tools and hammer.
Special Tool:
(B): 09924-74510 or equivalent.
(C): 09925-68210 or equivalent.
4. Apply grease to gear shift shaft oil seal at its lip and install it up to bottom of the bore by using special tool and hammer.
"B": SUZUKI SUPER GREASE A, or equivalent.
Special Tool (D): 09925-58210 or equivalent.
