Swift L4-1298cc 1.3L SOHC MFI (1997)
8. Install circlip, needle bearing, apply oil to bearing, then install 2nd gear synchronizer ring and 2nd gear.
CAUTION: Confirm that circlip is installed in groove securely.
9. Press-fit 3rd gear and spacer by using special tool and press.
Special Tool
(A): 09923-78210 or equivalent.
(D): 09913-80112 or equivalent.
NOTE: It is recommended to press-fit spacer and 3rd gear first, and then 4th gear later separately so that countershaft will not be compressed
excessively.
10. Press-fit 4th gear by using the same procedure as the above.
11. Install L bearing cone by using special tool and hammer.
Special Tool
(A): 09923-78210 or equivalent.
(E): 09925-98221 or equivalent.
NOTE: For protection of bearing cone, always support shaft with special tool as illustrated.
