Swift GA L4-1298cc 1.3L SOHC MFI (2001)
12. Check for water leakage by running water from hose over window. If leakage is found, dry window and fill leaky point with adhesive. If water still
leaks even after that, remove glass and start installation procedure all over again.
NOTE:
-
Do not use high pressure water.
-
Do not blow compressed air directly at adhesive applied part when drying.
-
Do not use an infrared lamp or the like for drying.
CAUTION:
Upon completion of installation, note the following.
-
Sudden closing of door before adhesive is completely set may cause glass to become loose or to come off. Therefore, if door is opened
or closed before adhesive is completely set, make sure to open all door glasses and use proper care.
-
If molding is not securely in place, hold it down with a tape until adhesive is completely set.
-
Each adhesive has its own setting time. Be sure to refer to maker's instruction, check setting time of adhesive to be used and observe
precautions to be taken before adhesive is set.
-
Refrain from driving till adhesive is completely set so as to ensure proper and sufficient adhesion.
