Swift GA L4-1298cc 1.3L SOHC MFI (2001)
Tie Rod Boot: Testing and Inspection
Manual Steering
STEERING RACK BOOT
Hoist vehicle.
Inspect each boot for tear. A torn boot allows entry of dust and water which can cause wear to steering rack and pinion to produce noise as well as rust
to result in malfunction of steering system. If even a small tear is noted, replace with new one.
Boots should be visually inspected for any damage and tear during every periodical inspection at specified intervals and whenever car is hoisted for
any other purpose.
TIE ROD END BOOTS
Inspect each boot for tear. If even a small tear is noted, replace with new one.
STEERING SHAFT JOINT
Check shaft joint for wear, breakage and other damage and replace if any defect exists.
TIE ROD END
1. Inspect for play in ball joint.
2. Inspect for play in rack end ball joint.
In either case, if found defective, replace.
