Swift GA L4-1298cc 1.3L SOHC MFI (2001)
2. Install rear bushing to suspension arm as follows. First, push in rear bushing in such direction and angle as shown in figure (A) and drive it into
such position as shown in figure (B).
3. Fit suspension arm bracket to suspension arm in such direction as shown in figure and hand-tighten bracket nut lightly and then install suspension
arm bracket to vehicle body.
At this point, tighten bracket bolt only lightly by hand.
4. Install ball stud to knuckle.
Align ball stud groove with knuckle bolt hole.
Then drive in ball stud bolt from the direction.
