Swift GL L4-1298cc 1.3L SOHC MFI (2000)
2. Apply oil to mechanical seal O-ring and install it over special tool (H). When fitting mechanical seal over the special tool, care should be taken
so as not to confuse its designated direction. The illustration shows the designated direction.
CAUTION: Do not reuse mechanical seal once removed from compressor.
3. Using special tool (G), press it slowly by hand until mechanical seal contacts the stopper of clutch installation boss.
Special Tool
(G): 09990 - 48230
NOTE: With mechanical seal pressed in completely, its upper face must come to a the position lower than circlip fitting groove. Check this
condition visually.
CAUTION: Do not use a press machine, hammer, etc. to push on special tool (G).
