Swift GL L4-1298cc 1.3L SOHC MFI (2000)
Starter Motor: Service and Repair
Unit Repair Overhaul
0.9 kw Conventional Type
For overhauling of starting motor, it is recommended that component parts should be cleaned thoroughly. However, yoke assembly, armature coil,
overrunning clutch assembly, magnetic switch assembly, rubber or plastic parts are NOT ALLOWED to be washed in degreasing tank or with grease
dissolving solvent. Those parts should be cleaned by blowing air and wiping with cloth.
DISASSEMBLY
NOTE: Before disassembling starting motor, be sure to put match marks at two locations (A and B) as shown in figure so that any possible mistakes can
be avoided.
1. Remove nut securing the end of field coil lead to terminal on the head of magnetic switch.
2. Take off magnetic switch from starting motor body by removing two mounting screws.
