Swift GL L4-1298cc 1.3L SOHC MFI (2000)
Control Arm Bushing: Service and Repair
REMOVAL
1. Hoist vehicle and remove wheel.
2. Remove stabilizer link nut, washer and cushion.
3. Remove ball stud bolt.
4. Remove suspension arm bracket nut.
5. Remove suspension arm bracket bolts.
6. Remove rear bracket and suspension arm.
7. Remove rear bushing with hydraulic press as shown.
8. Cut off flange of front bushing as shown in figure (A) and then push out front bushing by using hydraulic press as shown in figure (B).
INSTALLATION
1. Install front bushing. Before installing bushing, apply soap water on its circumference to facilitate installation. When installed, bush should be
equal on the right and left of arm as shown.
