Swift GL L4-1298cc 1.3L SOHC MFI (2000)
5. Install spring seat, bearing spacer and strut cover to spring upper seat and then install strut bracket with its center aligned with "A" mark on spring
upper seat.
6. Wash bearing lower washer and install it.
7. Wash strut bearing and apply grease. Install it on bearing lower washer.
8. Wash bearing upper washer and install it.
9. Install bearing seal, bearing seat, strut support, inner spacer, washer and strut nut in this sequence. Be careful for installing directions. Tighten strut
nut to specified torque and then apply waterproof coating (paint or lacquer) all around nut and strut rod thread.
Tightening Torque (a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
10. Loosen and remove special tool (A) compressing coil spring. While loosening special tool, recheck that stepped part of spring seat and spring end
are in place to each other as described in foregoing step 2.
11. Install strut to vehicle body.