Swift GL L4-1298cc 1.3L SOHC MFI (2000)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise vehicle and drain transmission fluid.
2. Remove oil pan from transmission. After removing oil pan bolts, tap around oil pan lightly with a plastic hammer for removal.
CAUTION:
-
Never hammer oil pan hard, or it may get deformed. It is recommended to hit oil pan indirectly through wood block.
-
Do not force oil pan off by using a flat tip screwdriver or the like as it may cause damage to gasket surface.
3. Remove gasket on mating surface thoroughly.
INSTALLATION
For oil pan installation, reverse its removal procedure using care for the following.
1. Make sure to use new gasket.
2. Clean inside of oil pan before installation.
3. Clean oil cleaner magnet and install it in the position right below oil strainer.
