SX4 2WD L4-2.0L (2007)
Hazard Flasher Relay: Testing and Inspection
TURN SIGNAL AND HAZARD WARNING RELAY INSPECTION
Reference: Turn Signal and Hazard Warning Relay Removal and Installation
1. Connect turn signal and hazard warning relay (1), battery (2) and six test bulbs ((12V, 21W) (3) and 12 V, 5W (4)) as shown.
2. Check turn L circuit
Connect terminal "5" and battery negative (-) terminal by a jumper wire. Check left side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal and hazard warning relay.
Reference flashing cycle
60-120 cycle/minute
