SX4 2WD L4-2.0L (2007)
6. Remove water pump and generator drive belt.
7. Remove P/S pump mounting bolts (1) and then remove P/S pump.
NOTE: Plug each port of removed pump to prevent dust or any other foreign matter from entering.
Installation
Reverse removal procedure, and then nothing the following instructions.
NOTE: Fill specified power steering fluid after installation and bleed air without failure.
Tightening torque
P/S pump mounting bolt: 25 Nm (2.5 kgf-m, 18.0 ft. lbs.)
High pressure pipe union bolt: 55 Nm (5.5 kgf-m, 40.0 ft. lbs.)
P/S Hose / Pipe Components
P/S Hose / Pipe Components
