SX4 4WD L4-2.0L (2008)
19.
Remove the glove box by squeezing the sides to allow the limiting bumper to pass through the opening. Then lower enough to allow the hinge to
release and set the glove box aside.
20.
Remove the filter cover from the blower case. Squeeze the tabs together on both sides and slide the cover straight out.
21.
Disconnect the electrical connector at the back side of the motor. The lock release is on the driver side of the connector as plugged into the motor.
22.
Remove the blower motor by removing the two screws.
23.
Pull the tab down then rotate the motor clockwise to release it from the housing.
