SX4 4WD L4-2.0L (2008)
11.
The rubber seal on the right and left edge of the cowl garnish will need to be removed for the garnish cover to clear the hood hinge.
12.
Clean out any debris found inside the cowl vent area between the cabin and engine compartment.
13.
Install the cowl vent cover at the center position and right position.
14.
Slide the rear side of the vent cover onto the existing stud.
15.
Remove the existing nut and mount the front side of the vent cover with the removed nut.
16.
Installation of the center vent cover is similar.
