SX4 4WD L4-2.0L (2008)
3.
Using a wet/dry shop vacuum, apply suction to the drain hose in order to dislodge any obstruction as well as remove trapped water.
4.
To apply maximum suction to the drain hose use an appropriate attachment or cover the hose with your finger enough to increase the suction to the
drain line.
5.
Apply the suction for a minute or two to drain the water and produce maximum drain line flushing.
6.
Remove vehicle from lift.
7.
Remove both front wiper blades. Make sure to mark the position of the shaft to aid in the re-installation.
8.
Remove the rubber seal from the top cowl garnish. Vacuum any debris found on top of the cowl top garnish.
