SX4 4WD L4-2.0L (2008)
Installation
1. Install hydraulic unit / control module assembly by reversing removal procedure noting the following.
Install ABS hydraulic unit / control module assembly bracket bolt as follows.
a) Tighten bracket bolt (1) and (2) by hand.
b) Then tighten bracket bolt to specified torque.
Tightening order (1) - (2)
NOTE: Brake pipe flare nuts (3) from master cylinder is attached M10 nut (ABS model) or M12 (ESP(R) model).
Tightening torque
Brake pipe flare nut for M10 a: 16 Nm (1.6 kgf-m, 11.5 ft. lbs.)
Brake pipe flare nut for M12 b: 19 Nm (1.9 kgf-m, 14.0 ft. lbs.)
ABS hydraulic unit / control module assembly bolt c: 9 Nm (0.9 kgf-m, 6.5 ft. lbs.)
ABS hydraulic unit / control module assembly bracket bolt d: 26 Nm (2.6 kgf-m, 19.0 ft. lbs.)
