SX4 4WD L4-2.0L (2008)
ABS
Front Wheel Speed Sensor Removal and Installation
CAUTION:
^
Do not pull wire harness when removing and installing front wheel speed sensor.
^
Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
Removal
1. Disconnect negative (-) cable from battery.
2. Disconnect front wheel speed sensor connector (1).
3. Hoist vehicle and remove wheel.
4. Remove harness clamp, clamp bolt (2).
5. Remove front wheel speed sensor (3) from knuckle.