SX4 4WD L4-2.0L (2008)
ABS
Rear Wheel Speed Sensor Encoder On-Vehicle Inspection
For 4WD model
Refer to "Rear Wheel Speed Sensor On-Vehicle Inspection". See: Testing and Inspection/Initial Inspection and Diagnostic Overview
For 2WD model
Before inspecting rear wheel speed sensor encoder, remove rear wheel speed sensor.
^
Check encoder (1) for crack, damage or deformation.
^
Turn wheel and check if encoder rotation is free from eccentricity and looseness.
^
Check that no foreign material is attached.
If any faulty is found, clean or replace.
ESP
Rear Wheel Speed Sensor Encoder On-Vehicle Inspection
Output Voltage Inspection
1. Disconnect negative (-) cable from battery.
2. Hoist vehicle a little.
3. Disconnect wheel speed sensor connector.
4. Set up measuring device as shown in figure, the resistance to 115 ohms and the power supply voltage to 12V
Caution:
Incorrect voltage and/or wrong connection cause damage to wheel speed sensor.
