SX4 4WD L4-2.0L (2008)
4. Remove bleeder plug and cap from caliper.
Assembly
Assemble parts in reverse order of disassembly, observing the following instructions.
CAUTION:
^
Wash each part cleanly before installation in the same fluid as the one used in master cylinder reservoir.
^
Never use other fluid or thinner.
^
Before installing piston seal and cylinder boot to cylinder, apply rubber grease included in piston seal set or brake fluid to them.
^
Install a new piston seal into groove in cylinder securely making sure that it is not twisted.
^
After reassembling brake lines, bleed air from them.
Before installing caliper to carrier, install slide pins with rubber grease included in slide pin / boot set applied into caliper carrier hole and check for its
smooth movement in thrust direction.
