SX4 4WD L4-2.0L (2008)
7. Crank engine with fully charged battery, and read the highest pressure on compression gauge.
NOTE:
^
For measuring compression pressure, crank engine at least 250 r/min by using fully charged battery.
^
If measured compression pressure is lower than limit value, check installation condition of special tool.
Compression pressure
Standard: 1400 kPa (14.0 kgf/cm2, 199.0 psi)
Limit: 1100 kPa (11.0 kgf/cm2, 158.0 psi)
Max. difference between any two cylinders: 100 kPa (1.0 kgf/cm2, 14.2 psi)
8. Carry out Steps 5) through 7) on each cylinder to obtain 4 readings.
9. After checking, install spark plugs and ignition coils.
10. Connect injector wire harness at connector.
11. Install air cleaner assembly.
