SX4 4WD L4-2.0L (2008)
4. Install connecting rod bearing cap (1) as follows.
NOTE: If connecting rod bolt is reused, make sure to check connecting rod bolt for deformation.
a) Point arrow mark (2) on cap to crankshaft pulley side.
b) Apply engine oil to new connecting rod bolts (3).
c) Tighten all connecting rod bolts to 15 Nm (1.5 kgf-m, 11.0 ft. lbs.).
d) Retighten them by turning through 45°.
e. Repeat step d) once again.
Tightening torque
Connecting rod bolt a: Tighten 15 Nm (1.5 kgf-m, 11.0 ft. lbs.), 45° and 45° by the specified procedure
