SX4 4WD L4-2.0L (2008)
(B):09915-78211
CAUTION: Be careful not to make special tool touch Exhaust manifold when installing because Exhaust manifold becomes very hot.
4. Start engine and warm it up to normal operating temperature.
NOTE: Be sure to place transmission gear shift lever in "Neutral" (shift selector lever to "P" range for A/T model), and set parking brake and
block drive wheels.
5. After warming up, raise engine speed to 4,000 r/min and measure oil pressure.
Oil pressure specification: More than 390 kPa (3.9 kgf/cm2, 55.5 psi)
6. After checking oil pressure, stop engine and remove oil pressure gauge.
7. Before reinstalling oil pressure switch (2), be sure to wrap its screw threads with sealing tape (1) and tighten switch to specified torque.
Tightening torque
Oil pressure switch a: 13 Nm (1.3 kgf-m, 9.5 ft. lbs.)
NOTE: If sealing tape edge is bulged out from screw threads of switch, cut it off.
