SX4 4WD L4-2.0L (2008)
Receiver Dryer: Service and Repair
Desiccant Removal and Installation
Removal
1. Remove condenser assembly referring to Condenser Assembly Removal and Installation:Manual Type.
2. Remove circlip (4) using special tool.
Special Tool
: 09900 06107
3. Remove the cap (1) from the receiver / dryer tank (2).
4. Remove desiccant (3).
Installation
Reverse the removal procedure noting the following instructions.
^
Replenish specified amount of compressor oil to compressor suction side referring to in Operation Procedure for Refrigerant Charge:Manual Type.
^
Do not remove desiccant from the plastic bag until just before inserting it into the receiver.
^
Apply compressor oil to O-ring (1).
^
Be sure to install circlip (2) with its flat face (3) directed to cap.
^
Install condenser assembly referring to Condenser Assembly Removal and Installation:Manual Type.
