SX4 4WD L4-2.0L (2008)
Drive Belt: Service and Repair
Engine - Charging System
Water Pump and Generator Drive Belt Removal and Installation
Removal
WARNING: Disconnect negative (-) cable at battery before removing and installing generator belt.
1. Hoist vehicle.
2. Remove right side engine under cover.
3. Loosen tensioner by turning the tensioner pulley (2) clockwise.
4. While holding the tensioner and belt loose, remove generator belt (1).
Installation
1. Loosen tensioner by turning the tensioner pulley (2) clockwise.
2. While holding the tensioner, install generator belt (1).
