SX4 4WD L4-2.0L (2008)
Wheels: Removal and Replacement
Wheel (with Tire) Removal and Installation
CAUTION: Never use heat to loosen tight wheel because application of heat to wheel can shorten life of wheel and damage wheel bearings.
Removal
1. Loosen wheel nuts by approximately 1801 (half a rotation).
2. Hoist vehicle.
3. Remove wheel with tire.
Installation
Wheel nuts must be tightened in sequence and to proper torque to avoid bending wheel or brake drum or disc as shown in the figure.
NOTE:
^
Before installing wheels, remove any build-up of corrosion on wheel mounting surface and brake drum or disc mounting surface by scraping
and wire brushing.
Installing wheels without good metal-to-metal contact at mounting surfaces can cause wheel nuts to loosen, which can later allow wheel to
come off while vehicle is moving.
^
Use the designated tire and wheel with tire pressure sensor for the vehicle with TPMS control module.
^
In case of using any undesignated tire and wheel without tire pressure sensor, TPMS control module flashes ON and OFF the low tire pressure
warning light. In case of using the designated tire and wheel with tire pressure sensor, register its tire pressure sensor code with TPMS control
