SX4 4WD L4-2.0L (2008)
Engine Control Module: All Technical Service Bulletins
Engine Controls - Replacement ECM Information
SX4
Section Title: Engine
TSB No. TS03 10117
Division: Automotive
Category: Technical
SUBJECT:
REPLACEMENT ECMs ARE SHIPPED BLANK AND MUST BE PROGRAMMED BEFORE OPERATION
MODEL(S):
SX4
YEAR:
2007
CONDITION:
After installation of ECM the engine cranks but will not start if ECM is not programmed.
CAUSE:
New ECMs are shipped blank.
CORRECTION:
It is required to use the Suzuki Diagnostic System (SDS) Tool to program the blank ECM. See below for requirements and procedure. This procedure is
unique and to be used for blank ECM installation. Removal and replacement (R&R) warranty time listed in the warranty flat rate manual already includes
programming time.
REQUIRED TOOLS AND SOFTWARE:
WARRANTY CLAIM INFORMATION
Programming Procedure:
1.
Log onto Suzuki Connect and access the Suzuki Pitstop.