SX4 4WD L4-2.0L (2008)
Engine Control Module: All Technical Service Bulletins
Engine Controls - Blank ECM Fails To Program
Section Title: Engine
TSB No.: TS 07 10218
Division: Automotive
Category: Technical
SUBJECT:
BLANK ECM FAILS TO PROGRAM
MODEL(S):
SX4
YEAR:
2007~
CONDITION:
ECM fails to program within a 5 minute time frame and Suzuki ECU Programming System (SEPS) shows an error code.
CAUSE:
Precautions shown below, which are also located in the operators manual for SEPS, have not been followed.
CORRECTION:
Please write down error code. Make sure all below precautions are followed and program the ECU again. If the ECM still fails to program please
contact the S.M.A.R.T hotline (refer to Administrative Bulletin SA-02R for contact information).
NOTE:
If a part number appears which matches another vehicle model ECM during programming setup, please contact S.M.A.R.T hotline before continuing
programming.
