SX4 4WD L4-2.0L (2008)
WARNING: Use the nitrogen gas. If other kind of gas is used instead of the nitrogen gas, the gasoline may ignite and explode.
NOTE: A large difference between the vehicle temperature and shop temperature will seriously affect the accuracy of the tests. Always allow enough
time for the vehicle s temperature to adjust to the shop temperature.
If the pressure regulator is replaced, perform the calibration referring to Output Pressure Calibration in this instructions.
1. Connect the red battery clip from the tester to the positive battery terminal, and then connect the black battery clip from the tester to chassis
ground.
NOTE: The vehicle battery must be fully charged for optimum tester performance.
2. Turn the NITROGEN/SMOKE valve (1) on the front control panel to NITROGEN.
NOTE: Unwind the nitrogen/smoke hose completely from the bracket to optimize the tester s performance.
3. Connect the nitrogen/smoke hose (2) to 0.020 in. (0.5 mm) test orifice (3) on the bottom-front of the tester.
