SX4 4WD L4-2.0L (2008)
sufficient ventilation is provided. Ensure no loose or flammable object exists within deployment area.
b. Place driver air bag (inflator) module (1) with its vinyl trim cover facing up (2) on ground in Step a.
^
For passenger air bag (inflator) module
a. Clear space (3) on ground about 185 cm (6 ft) in diameter where passenger air bag (inflator) module (1) is set for deployment. Paved,
outdoor location where there is no activity is preferred. If outdoor location is not available, use space on shop floor where there is no
activity and sufficient ventilation is provided. Ensure no loose or flammable object exists within deployment area.
b. Place deployment fixture (A) on ground in Step a.
Special Tool
(A): 09932 75041
c. Fill plastic reservoir in deployment fixture (A) with water or sand. This is necessary to provide sufficient stabilization of fixture during
deployment.
d. Attach passenger air bag (inflator) module (1) in deployment fixture (A) securely using M8 bolt (2).
CAUTION: Be sure to use M8 size and 7T strength bolt for fixing passenger air bag (inflator) module (1) to deployment fixture
(A).
^
For seat belt pretensioner
