SX4 4WD L4-2.0L (2008)
a. Connect adapter cable (B) to seat belt pretensioner.
b. Pile 2 wheel-installed tires (3) on top of tire with seat belt pretensioner (6), and tie them with wire harness (5) as shown.
Wire harness specifications
Stripped wire harness section 1.25 sq.mm (0.0019 sq.in) or more (Stripped wire harness diameter 1.25 mm (0.05 in.) or more)
NOTE: Wind wire harness (5) around at least 2 times.
c. Drape blanket (7) over those tires.
11. Connect adapter cable (B) to deployment harness (A) connector and lock connectors with lock lever.
12. Notify all people in immediate area that you intend to deploy / activate air bag (inflator) module or seat belt pretensioner.
NOTE:
^
When air bag (inflator) module deploys and seat belt pretensioner activates, rapid gas expansion will create substantial report. Wear suitable
ear protection. Notify all people in immediate area that you intend to deploy air bag (inflator) module or activate seat belt pretensioner and
suitable ear protection should be worn.
^
When driver air bag (inflator) module deploys, driver air bag (inflator) module may jump about 30 cm (1 ft) vertically. This is normal reaction
to force of rapid gas expansion inside of drive air bag (inflator) module.
^
After air bag (inflator) module has been deployed, surface of air bag (inflator) may contain powdery residue. This powder consists primarily of
cornstarch (used to lubricate bag (inflator) as it inflates) and by-products of chemical reaction.
WARNING:
^
Do not place deployed air bag (inflator) module and activated seat belt pretensioner near any flammable objects.
^
Do not apply water, oil, etc. to deployed air bag (inflator) module and activated seat belt pretensioner.
^
After driver / passenger air bag (inflator) module has been deployed wait for about 10 minutes before touching any part of its module.
^
After air bag (inflator) module and/or seat belt pretensioner have been deployed or activated, wait for about 30 minutes before
touching any metal surface of air bag (inflator) module or seat belt pretensioner module. Disregarding these precautions may cause
fire or personal injury. Failure to follow procedures may result in fire or personal injury.
13. Separate two banana plugs (1) on deployment harness.
14. Connect deployment harness to 12 volts vehicle battery (2). This will immediately deploy or activate air bag (inflator) module or seat belt
pretensioner.
