SX4 4WD L4-2.0L (2008)
8. Route deployment harness (1) out of vehicle.
9. Check that inside of vehicle and area surrounding vehicle are clear of all people and loose or flammable objects.
10. Stretch deployment harness (1) to its full length 10 m (33 ft).
11. Place 12 volts vehicle battery (2) near shorted end of deployment harness (1).
12. Completely cover windshield area and front door window openings with drop cloth, a blanket or any similar item. This reduces possibility of
injury due to possible fragmentation of vehicle's glass or interior.
13. Notify all people in immediate area that you intend to deploy air bag (inflator) module or activate seat belt pretensioners.
NOTE:
^
When air bag (inflator) module deploys or seat belt pretensioners activate, rapid gas expansion will create substantial report. Wear suitable ear
protection. Notify all people in immediate area that you intend to deploy air bag (inflator) module or to activate seat belt pretensioner and
suitable ear protection should be worn.
^
After air bag (inflator) module has been deployed, surface of air bag may contain powdery residue. This powder consists primarily of
cornstarch (used to lubricate air bag (inflator) module as it inflates) and by-products of chemical reaction.
WARNING:
^
Do not place deployed air bag (inflator) module and activated seat belt pretensioners near any flammable objects.
^
Do not apply water, oil, etc. to deployed air bag (inflator) module and activated seat belt pretensioners.
^
After driver / passenger air bag (inflator) module has been deployed wait for about 10 minutes before touching any part of its module.
^
After air bag (inflator) module and/or seat belt pretensioner have been deployed or activated, wait for about 30 minutes before
touching any metal surface of air bag (inflator) module or seat belt pretensioner module. Disregarding these precautions may cause
fire or personal injury.
Failure to follow procedures may result in fire or personal injury
14. Separate two banana plugs (1) on deployment harness (2).
15. Connect deployment harness (2) to 12 volts vehicle battery (3). This will immediately deploy or activate air bag (inflator) module or seat belt
pretensioners.
16. Disconnect deployment harness (2) from 12 volts vehicle battery (3) and short two deployment harness leads together by fully seating one banana
