SX4 4WD L4-2.0L (2008)
Installation
1. Using cleaning solvent, clean windshield edge where windshield glass is to be adhered. (Let it dry for more than 10 minutes.)
2. Install new glass stoppers (1) (2 pieces) to lower side of windshield (2) as shown.
3. To determine installing position of glass (1) to body (2), position glass against body so that clearance between upper end of glass (1) and body (2)
is approximately 5.5 mm (0.217 in.) and clearances between each side end (right & left) of glass (1) and body (2) are even. Then mark mating
marks (3) on glass (1) and body (2) as shown. Upper clearance can be adjusted by moving glass stoppers position.
