SX4 4WD L4-2.0L (2008)
12. Check for water leakage by pouring water over windshield through hose. If leakage is found, dry windshield and fill leaky point with adhesive. If
water still leaks even after that, remove glass and start installation procedure all over again.
NOTE:
^
Do not use high pressure water.
^
Do not blow compressed air directly at adhesive applied part when drying.
^
Do not use infrared light or like for drying.
CAUTION:
Upon completion of installation, note the following.
^
Sudden closing of door before adhesive is completely set may cause glass to become loose or to come off. Therefore, if door is opened
or closed before adhesive is completely set, make sure to open all door glasses and use proper care.
