Verona L6-2.5L (2005)
22.Turn off the ignition. Turn off the Tech II and disconnect it. Remove the indicated power wire from the ISU for ten seconds then reconnect. The ISU
is located to the left of the steering column next to the knee bolster panel. Start the procedure again from step 9.
23.Press YES to continue.
24.Turn the ignition OFF and press "Enter". At this point you may remove the key from the ignition.
25.The "Keyless transmitter registration" will flash until one of the transmitter buttons is pushed.
26.After one key transmitter button is pushed, you will have a choice to register another key.
27.Continue following the Tech 2 prompts to complete the process.
28.After completing scan tool transmitter registration: Exit the RKE function, power off the Tech 2 and unplug it from the DLC.
29.Verify key transmitter operation. If the transmitters do not operate immediately when tested, allow the keys to rest- do not use them for 5-7 minutes.
30.After 5-7 minutes verify repair by opening and locking doors with each key transmitter that was registered.
