Verona L6-2.5L (2005)
Front Cross-Member: Procedures
Centermember Assembly Removal and Installation
Centermember Assembly
Removal
1. Raise and suitably support the vehicle.
2. Remove the dust cover from the under body of the vehicle.
3. Remove the power steering pipe fixing bolts.
4. Remove the centermember front damping block bolt and rear damping block bolt.
WARNING: When removing the centermember bolt, the engine assembly should be supported by jack stands, in advance. Failure to
support the centermember properly can result in person injury. In addition, remove the centermember bolt with caution when the
exhaust pipe is hot.
5. Remove the centermember bolts and remove the centermember assembly.
Installation