Verona L6-2.5L (2005)
Seat Back: Service and Repair
Split Rear Seatback Lock Striker Removal and Installation
Split Rear Seatback Lock Striker Removal and Installation
Split Rear Seatback Lock Striker Removal
1. Lower the rear seatbacks.
2. Remove the rear seat side bolster cushion. Refer to Rear Seat Side Bolster Cushion Removal.
3. Remove the retaining clips and the back panel trim cover.
4. Remove the bolts and the seatback lock strikers.
Split Rear Seatback Lock Striker Installation
CAUTION: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
1. Install the seatback lock strikers with the bolts.
Tighten:
Tighten the rear seatback lock striker bolts to 25 N.m (18 lb.ft).
2. Install the back panel trim cover with the retaining clips.
3. Install the rear seat side bolster cushion. Refer to Rear Seat Side Bolster Cushion Removal.
4. Raise and secure the rear seatbacks in the upright position.
