Verona L6-2.5L (2005)
Brake Master Cylinder: Service and Repair
Disassembly and Assembly
Master Cylinder Disassembly
1. Remove the master cylinder.
2. Remove the brake fluid reservoir.
3. Remove the screw from the cylinder.
4. Remove and discard the retaining ring from the cylinder body by pressing the hollow shaft and using needle-nosed pliers to grasp and squeeze the
retaining ring.
CAUTION: When removing the retaining ring, avoid damaging the piston or the cylinder wall.
5. Remove the washer and the primary piston assembly.
6. Carefully remove the secondary piston assembly, including the spring, from the master cylinder bore.
Master Cylinder Assembly
CAUTION: Do not use abrasives in the master cylinder bore. Abrasives can damage the bore.
CAUTION: Rubber parts and retaining rings must be discarded and replaced with new parts.
