Verona L6-2.5L (2005)
Cruise Control Servo Cable: Service and Repair
Actuator Control Cable Removal and Installation
Actuator Control Cable Removal
1. Remove the coin storage and the screws.
2. Separate the hood release cable from the hood latch release handle.
3. Carefully remove the knee bolster trim panel by pulling until the retaining clips are free from the slots in the instrument panel.
4. Remove the knee bolster. Refer to Driver's Side Knee Bolster Removal.
5. Press the release button on the cable adjuster and push the cable toward the adjuster until the spring is compressed.
NOTE: When the adjuster button is pressed, do not allow the adjuster spring to expand to a length of more than 2 cm (3/4 inch) or the adjuster
rack will come out of the adjuster, and it will have to be reinserted. To keep the adjuster in one piece during adjustment, hold the cable when the
adjuster button is pressed.
