Verona L6-2.5L (2005)
4. Press the cable release button and slide the cable into the adjuster until the spring is fully compressed.
NOTE: When the adjuster button is pressed, do not allow the adjuster spring to expand to a length of more than 2 cm (3/4 inch) or the adjuster
rack will come out of the adjuster, and it will have to be reinserted. To keep the adjuster in one piece during adjustment, hold the cable when the
adjuster button is pressed.
5. Install the cable bushing into the pedal assembly.
6. Press the cable release button and adjust the cable to achieve a gap of 0.5 mm (0.2 inch) between the bushing and the nipple of the ball.
7. Install the knee bolster. Refer to Driver's Side Knee Bolster Installation.
8. Align the instrument panel under cover and press the retaining clips into the slots in the instrument panel.
9. Install the hood release handle screw.
Tighten:
Tighten the hood release handle screw to 2.5 N.m (22 lb.in).
