Verona L6-2.5L (2005)
7. Seat the connecting rod bearings and temporarily install the connecting rod cap.
NOTE: The sizes of the connecting rod bearings are identified by the color marks on the side of the bearing, which are green (Size-0) and yellow
(Size-1).
8. Install the thrust bearing.
NOTE: Make sure the oil groove on the thrust bearing is installed facing outside.
9. Tighten the connecting rod cap bolts using crankshaft adjuster DW110-190. Observe the tightening order of the connecting rod cap bolts as
follows: 2 - 5 - 1 - 6 - 3 - 4 (piston number).
