Verona L6-2.5L (2005)
Engine Mount: Service and Repair
Engine Mount (LH) Removal and Installation
Engine Mount (LH) Removal
1. Disconnect the negative battery cable.
2. Remove the transaxle mount cage nut/bolts.
Engine Mount (LH) Installation
1. Installation should follow the removal procedure in the reverse order.
2. Install the engine mount (LH).
Tighten the four (4) transaxle mount cage-to-longitudinal member bolts to 55 - 75 Nm (41 - 55 ft. lbs.).
Tighten the transaxle mount cage-to-transaxle mount bracket bolt to 55 - 75 Nm (41 - 55 ft. lbs.)
Tighten the transaxle mount cage-to-transaxle mount bracket nut to 55 - 75 Nm (41 - 55 ft. lbs.)
Tighten the transaxle mount cage through bolt to 100 - 120 Nm (74 - 89 ft. lbs.).