Verona L6-2.5L (2005)
29. Clean the contact surfaces between intake manifold and the cylinder head.
NOTE: Remove the fuel rail after removing the intake manifold.
Intake Manifold Installation
1. Installation should follow the removal procedure in the reverse order.
2. Discard used intake manifold gaskets and install new ones.
3. Tighten the intake manifold retaining nuts and bolts.
NOTE: Install the intake manifold after installing the fuel rail.
CAUTION: Genuine intake manifold retaining bolts within the specifications should be used to prevent damaged intake manifold from impairing
the airflow to the cylinder.
Tighten the seven (7) intake manifold retaining bolts to 10 - 14 Nm (89 - 124 inch lbs.).
Tighten the four (4) intake manifold retaining nuts to 10 - 14 Nm (89 - 124 inch lbs.).
Tighten the two (2) bolts on the intake manifold support bracket to 10 - 14 Nm (89 - 124 inch lbs.).