Verona L6-2.5L (2005)
Heater Core Case: Service and Repair
Heater/Air Distributor Case Assembly Removal and Installation
Heater/Air Distributor Case Assembly Removal
1. Disconnect the negative battery cable.
2. Remove the instrument panel carrier assembly. Refer to Instrument Panel Removal.
3. Drain the cooling system. Refer to Draining and Refilling the Cooling System.
4. Twist the vacuum hose connection and remove it from beside the heater hoses.
5. Compress the heater hose clamps at the fire wall and slide the clamps toward the engine.
6. Remove the two heater hoses from the core pipes at the fire wall.
7. Remove the screws that secure the to the fire wall on either side of the heater hoses.
8. Remove the screw from above the brake pipe on the engine compartment side of the fire wall.
9. Have an assistant support the from inside the vehicle.
10. Remove the screws from the connecting block mount on the engine compartment side of the fire wall. That will start to drop.
CAUTION: To avoid damaging the heater core pipes, move the straight away from the vehicle until the pipes are free from their openings in the
fire wall.
