Verona L6-2.5L (2005)
11. Remove the heater/air distributor case assembly.
Heater/Air Distributor Case Assembly Installation
1. Position the heater/air distributor case assembly in the vehicle.
CAUTION: To avoid damaging the vehicle, make sure the heater core pipes do not contact the fire wall opening.
2. Slowly raise the heater/air distributor case assembly into position against the fire wall and hold it there while the screws are installed and tightened
from the engine side of the fire wall.
3. Install the heater/air distributor case assembly screws at the connecting block mount on the engine compartment side of the fire wall.
Tighten:
Tighten the heater/air distributor case assembly screws to 8 N.m (71 lb.in).
4. Align and install the heater/air distributor case assembly screw above the fuel filter.
Tighten:
Tighten the heater/air distributor case assembly screw to 8 N.m (71 lb.in).
