Verona L6-2.5L (2005)
Tail Lamp: Service and Repair
Rear Combination Lamps Removal and Installation
Rear Combination Lamps Removal
1. Disconnect the negative battery cable.
2. Disconnect the electrical connectors.
3. Remove the nuts and the lamp assembly.
4. Remove any inoperative bulb.
Rear Combination Lamps Installation
1. Install the replacement bulbs.
CAUTION: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the lamp assembly with the nuts.
Tighten: Tighten the rear combination lamp assembly nuts to 2 N.m (18 lb.in).
3. Connect the electrical connectors.
4. Connect the negative battery cable.
