Verona L6-2.5L (2005)
6. Check the oil fluid level. If fluid does not drain through the plug hole after adding a total of 4 liters, then the transaxle was either underfilled or the
transaxle is leaking fluid. Inspect the transaxle for fluid leaks. Fix any leaks before setting the transaxle fluid level.
7. Install the fluid level plug using the plug remover/installer DW260-070.
Tighten: Tighten the Plug to 45 Nm (33 ft. lbs.).
8. When the fluid level checking procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid
fill cap and the vent tube are properly installed.
