Verona L6-2.5L (2005)
Oxygen Sensor: Service and Repair
Oxygen Sensor (O2S) Removal And Installation
Oxygen Sensor (O2S) Removal
1. Disconnect the negative battery cable.
CAUTION: The oxygen sensor (O2S) uses a permanently attached pigtail and connector. This pigtail should not be removed from the O2S.
Damage or removal of the pigtail or the connector could affect proper operation of the O2S. Take care when handling the O2S. Do not drop or
damage the O2S.
2. Disconnect the oxygen sensor wiring harness connector.
3. Remove the exhaust manifold feat shield bolts.
