Verona L6-2.5L (2005)
Impact Sensor: Service and Repair
Side Airbag Sensor Removal and Installation
Side Airbag Sensor Removal
WARNING: The sensing and diagnostic module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for 1 minute
after the ignition is OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until one
minute has passed after disconnecting power to SDM. If the airbags are disconnected, service can be executed immediately without waiting for
one-minute time period to expire. Failure to temporarily disable the SIR during service can result in unexpected deployment, personal injury
and unnecessary SIR repairs.
1. Disconnect the negative battery cable.
2. Remove the trim from B pillar.
3. Remove the side airbag sensor mounting bolts.
4. Remove the side airbag sensor.
Side Airbag Sensor Installation
1. Install the side airbag sensor.
2. Install the side airbag sensor mounting bolts.
Tighten:
Tighten the side airbag sensor mounting bolts to 10 N.m (89 lb.in).
3. Install the trim on B pillar.
4. Connect the negative battery cable.
