Verona L6-2.5L (2005)
Alternator: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the serpentine accessory drive belt by lowering the vehicle and turning the automatic tensioner roller bolt clockwise to relieve tension on
the belt. Refer to Serpentine Accessory Drive Belt Removal.
3. Disconnect the harness connector from the back of the generator, and the generator lead to the battery.
4. Carefully remove the generator with the bolts.
INSTALLATION
1. Install the generator to the generator bracket and insert the generator bolt.
Tighten:
Tighten the generator bracket upper bolt to 35 Nm (26 lb-ft).
Tighten the generator bracket lower bolt to 40 Nm (30 lb-ft).
