Verona L6-25L (2005) Starter Motor Disassembly and Assembly Guide
1. Install the starter-to-engine block mounting bolt and the transmission-to-starter mounting bolt.
Tighten:
Tighten the starter-to-engine block mounting bolt to 45 Nm (33 lb-ft).
Tighten the transmission-to-starter mounting bolt to 50 Nm (37 lb-ft).
2. Position the starter electrical wire on the solenoid terminals and the ground wire.
3. Install the starter solenoid nut.
Tighten:
Tighten the starter solenoid nut to 7 Nm (61 lb-in).
4. Connect the starter solenoid connector.
5. Install the air inlet hose.
6. Install the air Inlet hose bolts.
Tighten:
Tighten the air Inlet hose bolts to 6 Nm (53 lb-in).
7. Connect the negative battery cable.